Filter
Top Products
37
BURNERS
They can be removed and washed only with soapy
water. Detergents can be used but must not be
abrasive or corrosive.
Do not use abrasive sponges or pads.
Do not put in dishwasher.
After each cleaning, make sure that the
burner-caps, as well as the burners, have
been well wiped off and CORRECTLY
POSITIONED.
It is essential to check that the burner flame
distributor F and the cap C has been correctly
positioned (see fig. 36) - failure to do so can
cause serious problems.
Check that the electrode S (fig. 36) is always
clean to ensure trouble-free sparking.
Check that the probe T (fig. 36) next to each
burner is always clean to ensure correct
operation of the safety valves. Both the probe
and ignition plug must be very carefully cleaned.
Note:
The electrode S must be very carefully
cleaned. To avoid damage to the electric
ignition do not use it when the burners are
not in place.
Figure 36
F
C
S
TRIPLE RING BURNER
The triple ring burner must be correctly positioned (see fig. 37); the burner rib must be
located in position as shown by the arrow.
The burner correctly positioned must not rotate (fig. 38).
Then position the cap A and the ring B (fig. 38).
A
B
Figure 37 Figure 38
T