Filter
Top Products
Page 11Page 22
Using Your Dishwasher Installation
STARTING A WASHING PROGRAM
Wash Cycle Table
NOTE: Star ( ) means the need to fill rinse aid into the Rinse Aid Dispenser.
NOTE:
* AS/NZS 2007.1: This program is the test cycle.
The information for comparability test in accordance with AS/NZS 2007.1, as follows:
Capacity: 15 setting
Ÿ
Position Upper basket: Upper wheels on rails
Ÿ
Rinse aid setting: 6
Ÿ
Open the door slightly 50mm to assist in drying of the dishes after every wash
Ÿ
(Or All )in1
5/28.75g
Detergent
pre/main
Cycle Selection
Information
Program
Running
time(min)
Water
(L)
Energy
(Kwh)
Rinse
Aid
For heavily soiled loads,
such as pots, plates,
glasses and lightly
soiled pans.
Standard daily cycle for
normally soiled loads,
such as pots, plates,
glasses.
For heaviest soiled crockery,
and normally soiled pots,
pans, dishes etc with dried
on soiling.
A shorter wash for lightly
soiled loads that do not
need drying.
Pre-wash(50 °C)
Wash (65 °C)
Rinse
Rinse
Rinse (65°C)
Drying
Pre-wash(45°C)
Wash (55 °C)
Rinse
Rinse (60 °C)
Drying
Pre-wash
Wash (55 °C)
Rinse
Rinse(45°C)
Drying
Wash (40 )
Rinse
Rinse (45 °C)
°C
170
175
155
40
1.15
0.62
1.45
0.5
17.0
13.5
12.0
10
Description
of Cycle
Pre-wash(50°C)
Wash(60°C)
Rinse (50°C)
Drying
60 90.8
20g
For lightly soiled loads that
do not need excellent
drying efficiency.
To rinse dishes that you plan
to wash later that day.
Pre-wash
8
0.01
3.8
For lightly soiled crockery
and glass.
115 0.85
13.5
Pre-wash
Wash (40 °C)
Rinse
Rinse(60°C)
Drying
10~13.5
1.1~1.4
120~170
Pre-wash (45 °C)
Autowash(50-60 °C)
Rinse
Rinse (60 °C)
Drying
Auto sensing wash, lightly,
normally or heavily soiled
crockery, with or with out
dried-on food
(Or All )in1
5/28.75g
(Or All )in1
5/28.75g
(Or All )in1
5/28.75g
5/28.75g
5/28.75g
Intensive
Normal
Rapid
60 Min
Glass
Soak
Heavy
(*AS/NZS 2007.1)
Auto
Drain Hose Connection
Insert the drain hose into a drain pipe with a
Ÿ
minimum diameter of 40mm, or let it run into the
sink, making sure to avoid bending or crimping it.
The top of the hose must be at a height less than
1000mm. The free end of the hose must not be
immersed in water to avoid back flow.
Syphon Connection
Insert the drain hose into a drain pipe with a
Ÿ
minimum diameter of 40mm, or let it run into the
sink, making sure to avoid bending or crimping it.
The top of the hose must be less than 1000mm.
How to Drain Excess Water from Hoses
If the sink is more than 1000mm higher than the
Ÿ
floor, the excess water in the hose cannot be
drained directly into the sink. It will be necessary to
drain excess water from the hose into a bowl or
suitable container that is held outside and lower
than the sink.
Water Outlet
Connect the water drain hose. The drain hose must
Ÿ
be correctly fitted to avoid water leaks. Ensure that
the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to
Ÿ
use a similar drain hose.
It must be no longer than 4 metres; otherwise the
Ÿ
cleaning effect of the dishwasher could be
reduced.
MAX 1000mm
A
Counter
Front
Drain pipe
NOTE
The top of the hose
must be less than
1000mm.
¦40mm
B
Electrical Connection
Connect the appliance power cord in accordance
Ÿ
with the precautions outlined on page 7.
Positioning the Appliance
Position the appliance in the desired location. The
Ÿ
back should rest against the wall behind it, and the
sides, along the adjacent cabinets or walls. The
dishwasher is equipped with water supply and
drain hoses that can be positioned either to the
right or the left sides to facilitate proper installation.
Affix the condensation strip under the work surface
Ÿ
of the cabinet. Ensure the condensation strip is
flush with edge of the work surface.
Condensation
Strip