Filter
Top Products
Page 12 Page 21
Using Your DishwasherInstallation
Damage to glassware and other dishes
Possible Causes
Type of glass or manufacturing process. Chemical
Ÿ
composition of detergent.
Water temperature and duration of dishwasher
Ÿ
program.
Suggested remedy:
Use glassware or porcelain dishes that have been
Ÿ
marked dishwasher-proof by the manufacturer.
Use a mild detergent that is described as kind of
Ÿ
dishes If necessary, seek further information from
detergent manufacturers.
Select a program with as low a temperature.
Ÿ
To prevent damage, take glass and cutlery out of
Ÿ
the dishwasher as soon as possible after the
program has ended. as possible after the program
has ended.
Cutlery Basket
Cutlery should be placed in the cutlery rack
separately from each other in the appropriate
positions shown below. Make sure the utensils do
not nest together, this may cause bad performance.
For a top quality clean, place the silverware in the
basket making sure that:
They do not nest together.
Ÿ
Silverware is placed with the male face up.
Ÿ
Long utensils in the middle.
Ÿ
Teaspoons4
Soup spoons2
Forks
1
Knives
5
3 Dessert spoons
Levelling the Dishwasher
The dishwasher must be level for proper dish rack
Ÿ
operation and wash performance.
Once the appliance is positioned for levelling, the
Ÿ
height of the dishwasher may be altered via
adjustment of the screwing level of the feet. In any
case, the appliance should not be inclined more
than 2 °.
The rear feet can be adjusted from the front of the
Ÿ
dishwasher by turning the Allen screw in the middle
of the base of the dishwasher using an Allen key.
To adjust the front feet, use a flat screw driver and
Ÿ
turn the front feet until the dishwasher is level.
B
A
Place a level on the door and rack track inside the
Ÿ
tub as shown to check that the dishwasher is level.
If necessary, level the dishwasher by adjusting the
Ÿ
three levelling legs individually.
When levelling the dishwasher, please pay
Ÿ
attention not to let the dishwasher tip over.
The maximum adjustment height of the feet is
Ÿ
50mm.
Spirit level
Spirit level
Check level side to side.
Check level Front to Back.
Securing the Dishwasher
The dishwasher must be secured in place using either
of the following methods:
Normal work surface - Put the right(left) installation
Ÿ
hook into the slot of the right(left) side plane and
secure it to the work surface with two woodscrews
(Pic 1).
Marble or granite work top - Bend the right(left)
Ÿ
installation hook into right-angle,and put it into the
slot of the right(left) side plane and secure it to the
work surface with two woodscrews (Pic 2).
IN
5
1
2
5
3
5
1
5
4
2
Pic 1
Pic 2