Filter
Top Products
Care and Cleaning
Page 25Page 8
90° 90°
820mm
580mm
80
100
600mm
Electrical, drain
and water supply
line entrances
Space between cabinet
bottom and floor
Cabinet
Dishwasher
Dishwasher
Door
Min. space
of 50mm
Aesthetic Fascia Panel Dimensions and
installation
The aesthetic fascia panel should be processed
Ÿ
according to the diagram below.
If the dishwasher is installed in the corner of a
Ÿ
cabinet, there should be clearance when the door is
opened as shown below.
Minimum space between the door and adjacent
Ÿ
cabinet when the door is opened is 50mm.
Front View
Section A-A
(Side View)
Installation
Open
Filtering System
The filter prevents larger remnants of food or other
objects from getting inside the pump.
The residue may block the filter, in this case they must
be removed.
The filter system consists of a coarse filter, a flat (Main
filter) and a microfilter (Fine filter).
3
2
1
MAIN FILTER: Food and soil particles trapped
in this filter are pulverized by a special jet on the
lower spray arm and washed down the drain.
COARSE FILTER: Larger items, such as
pieces of bones or glass, that could clog the
drain are trapped in the coarse filter. To
remove an item caught in this filter, gently
squeeze the taps on the top of this filter and
lift it out.
FINE FILTER: This filter holds soil and food
residues in the sump area and prevents it from
being redeposit on the dishes during a cycle.
1
2
3
Filter Assembly
The filter efficiently removes food particles from the
wash water, allowing it to be recycled during the cycle.
For best performance and results, the filter must be
cleaned regularly. For this reason, it is a good idea to
remove the larger food particles trapped in the filter
after each wash cycle by rinsing the semicircular filter
and cup under running water.
To remove the filter device, pull the cup handle in the
upward direction.
WARNING!
The dishwasher must never be used without the
Ÿ
filters.
Improper replacement of the filter may reduce the
Ÿ
performance level of the appliance and damage
dishes and utensils.
1
2
STEP 1: Turn the filter in anti-clockwise direction.
STEP 2: Lift the filter assembly up.
NOTES:
When following this procedure from step 1 to step
Ÿ
2, the filter system will be removed; when following
it from Step 2 to Step 1, the filter system will be
installed.
Inspect the filters for blocking after every time the
Ÿ
dishwasher has been used.
By unscrewing the coarse filter, you can remove the
Ÿ
filter system. Remove any food remnants and clean
the filters under running water.
The entire filter assembly should be cleaned once a
Ÿ
week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use a
cleaning brush. Reassemble the filter parts as shown
in the figures on the last page and reinsert the entire
assembly in the dishwasher, positioning it in its seat
and pressing downwards.
WARNING!
When cleaning the filters, do not knock on them.
Ÿ
Otherwise, the filters could be contorted and the
performance of the dishwasher could be
decreased.
5
20 (MAX)
2-Ø11
2-Ø5.5
A-A
A
436
A A
4-Ø2
8-Ø2
38
30
474.8
517
710 (MAX)
127
75±0.2
62
2-Ø2
A
589
566±0.2
451±0.22
540±0.22
ATTENTION: The installation of the pipes and
Ÿ
electrical equipment should be done by an
authorised person.
WARNING: Electrical Shock Hazard - Disconnect
Ÿ
electrical power before installing dishwasher.
Failure to do so can result in death or electrical
shock.
Cabinet Preparation
The installation position of dishwasher should be
Ÿ
near the existing inlet and drain hoses and power
cord. Preparations should be made before
moving the dishwasher to the installation place.
One side of the cabinet sink should be chosen to
Ÿ
facilitate the connection of drain hoses of the
dishwasher.
Cabinet dimensions should be less than 5mm
Ÿ
between the top of dishwasher and cabinet and the
outer door aligned to cabinet.
Note: please check the accompanying installation
accessories (hook for aesthetic panel & screws).