Filter
Top Products
10
FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 30 to 40mm thick.
The kit includes two “F” type brackets (for the front of the cooktop), two “R” type brackets
(for the rear of the cooktop) and four self-threading screws “S” (gs. 7a and 7b).
– Cut the unit according to the dimensions in g. 3a or 3b.
– Turn the hob upside down and rest the glass side on a soft surface.
– Spread the seal “G” around the edge of the hob (g. 6).
– Fasten the brackets “F” and “R” to the appropriate socket holes, without tightening the
screws “S” for the moment. Make sure that the tabs are mounted correctly, as shown.
Rotate the tabs so that the cooktop can be put into the cutout.
– Put the cooktop into the cutout and position it correctly.
– Put the brackets “F” and “R” into place; tooth “A” of the brackets should go into the hole
(Figs. 7a and 7b).
– Tighten screws “S” until the cooktop is
completely secured to the bench.
– Using a sharp cutter or trimmer kni-
fe, trim the excess sealing material
around the edge of the cooktop.
Take care not to damage the
workbench.
3 cm
min
3 cm
4 cm
S
A
R
3 cm
min
A
3 cm
4 cm
F
S
Adhesive side
G
G
Rear Fixing Brackets Front Fixing Brackets
Figure 6
Figure 7a Figure 7b