Filter
Top Products
10
is normal to hear the noise of boiling water.
After this, the noise diminishes.
• Toenjoyyourcoffeeevenmoreandimprove
the performance of your appliance, we
recommend installing a water softener
filter as described in the section “WATER
SOFTENER FILTER” (pg. 19). If your model
is not provided with a filter, you can request
one from De’Longhi Customer Services.
TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, press the main
switch on the back of the appliance (fig. 1).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which
cannot be interrupted. The appliance is ready for
use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of
the coffee spouts and is collected in the drip
tray underneath. Avoid contact with splashes of
water.
• To turn the appliance on, press the
button (fig. 5). The message “Heating
up... Please wait” is displayed.
After heating, the message “Rinsing...” is
displayed. As well as heating the boiler, the
appliance also heats the internal circuits by
circulating hot water.
The appliance is at temperature when a message
indicating the coffee taste and quantity is
displayed.
TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be
interrupted.
Danger of burns!
During rinsing, a little hot water flows from the
coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the button
(fig. 5). The appliance performs a rinse cycle,
then the message “Turning Off Please wait...” is
displayed and the appliance goes off.
Please note!
If the appliance is not used for an extended
period, also release the main switch (fig. 1).
Important!
To avoid damaging the appliance, never release
the main switch (fig. 1) while the appliance is
on.
MENU SETTINGS
When you access the programming menu by pressing
the P button, the following menu items are available:
Descale
For instructions on descaling, see page 18.
Adjust time
To adjust the time on the display, proceed as
follows:
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 7) until “Adjust
time” is displayed;
3. Press the button (fig. 2);
4. Turn the selection knob (fig. 7) to change the
hours;
5. Press the button to confirm;
6. Turn the selection knob (fig. 7) to change the
minutes;
7. Press the button to confirm.
This sets the time. Press the button to exit
the menu.
Auto-off
The appliance is set to turn off automatically if
not used for 2 hours.
The time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1,
2 or 3 hours.
To re-program Auto-off, proceed as follows:
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 7) until “Auto-
off” is displayed;
3. Press the button;
4. Turn the selection knob (fig. 7) until the
desired operation time is displayed (15 or 30
minutes, or 1, 2 or 3 hours);
5. Press the button to confirm;
6. Press the button to exit the menu.
Auto-off is programmed.