Filter
Top Products
15
EN
(Making cappuccino or macchiato), pressing the
CAPPUCCINO button twice instead of once.
Please note!
If during delivery you want to stop making milk
or coffee, press the CAPPUCCINO button once.
Preparing milk (unfrothed and without coffee)
Proceed as described in the previous paragraph
(Making frothed milk), turning the froth
adjustment knob to position 1 (fig. 20).
Cleaning the milk frother with the CLEAN
button
“Press CLEAN button” flashes on the display
each time you use a milk function.
To eliminate all milk residues, proceed as
follows:
1. Leave the milk container in the machine (you
do not need to empty it);
2. Place a cup or other recipient under the
frothed milk spout.
3. Press the CLEAN button (fig. 21) and keep
pressing until the progress bar which
appears on the display together with the
message “Cleaning...” is complete.
Please note!
• Ifyouaremakinganumberofcappuccinos
one after the other, you do not need to clean
by pressing the CLEAN button each time you
make a cappuccino. Just press it once after
making the last cappuccino (the appliance
can continue making cappuccino or coffee
even if the CLEAN button is not pressed).
• Afteruse,alwayscleanthehotwater/steam
nozzle and the milk container as described
on pages 17-18.
Programming the quantity of coffee and milk
in the cup for cappuccino or milk
The appliance is set by default to automatically
deliver standard quantities.
To change these quantities, proceed as follows:
1. Place a cup under the coffee and milk
spouts.
2. Hold the CAPPUCCINO button until the
message “Milk for Cappuccino Program
Quantity” is displayed.
3. Release the button. The appliance starts
delivering milk.
4. Once the required quantity of milk has
been delivered into the cup, press the
CAPPUCCINO button again.
5. The appliance stops delivering milk and after
a few seconds the coffee is delivered into the
cup. “Coffee for Cappucc. Program Quantity”
is displayed.
6. Once the required quantity of coffee has
been delivered into the cup, press the
CAPPUCCINO button. Coffee delivery stops.
The machine is now reprogrammed with the new
quantities.
HEATING WATER
Important! Danger of burns.
Never leave the machine unsupervised while
delivering hot water.
The spout becomes hot during delivery. Hold by
the plastic handle only.
1. Make sure the hot water spout is attached
correctly (fig. 4).
2. Place a container under the spout (as close
as possible to avoid splashes).
3. Press the button (fig. 2). “Hot water…”
is displayed, together with a progress
bar which fills gradually as preparation
proceeds.
4. The machine delivers 8.5 oz / 250 ml of hot
water, then delivery stops automatically. To
interrupt delivery of hot water manually,
press the button again.
Please note!
If “Energy Saving” mode is active, you may have
to wait a few seconds before the hot water is
delivered.
Change the quantity of water delivered
automatically.
The machine is set by default to automatically
delivery 8.5 oz / 250 ml of hot water.
To modify these quantities, proceed as follows:
1. Position a container under the spout.
2. Press the button again until “Hot Water
Program Quantity” is displayed, then release
the button.
3. When the hot water in the cup reaches the
required level, press the button again.
The machine is now reprogrammed with the new
quantity.