Filter
Top Products
14
Making coffee using pre-ground coffee
Important!
• Never add pre-ground coffee when the
machine is off or it could spread through the
inside of the machine and dirty it. This could
damage the appliance.
• Never use more than 1
level measure or it could
dirty the inside of the
coffee maker or block the
funnel.
Please note!
If you use pre-ground coffee, you can only
make one cup of coffee at a time.
1. Press the button (fig. 6) until “Pre-
ground” is displayed.
2. Make sure the funnel is not blocked, then
add one level measure of pre-ground coffee
(fig. 13).
3. Place a cup under the coffee spouts.
4. Press the 1 cup coffee button (fig. 8).
5. Preparation begins. The amount of coffee
selected is displayed together with a progress
bar which gradually fills as preparation
progresses.
MAKING DRINKS WITH MILK
Please note!
To avoid milk with poor froth or large bubbles,
always clean the milk lid and hot water nozzle
as described in the section “Cleaning the milk
container” on pages 15 and 17.
Filling and attaching the milk container
1. Remove the lid (fig. 14);
2. Fill the milk container with a sufficient
quantity of milk, not exceeding the MAX level
marked on the container (fig. 15). Each mark
on the side of the container corresponds to
3.4 oz / 100 ml of milk.
Please note!
• For a denser more even froth, we
recommend using skim or 2% milk
at refrigerator temperature (about
41°F/5°C).
• Toavoidproducingmilkwithpoorfroth
or large bubbles, always clean the milk
lid and hot water nozzle as described in
the sections “Cleaning the milk frother
with the CLEAN button” on page 15 and
“Cleaning the milk container” on page
17.
3. Make sure the milk intake tube is correctly
inserted in the bottom of the milk container
lid (fig. 16).
4. Place the lid back on the milk container.
5. Remove the hot water spout from the nozzle
(fig. 17).
6. Attach the milk container to the nozzle and
push as far as it will go (fig. 18). The machine
emits a beep.
7. Place a sufficiently large cup under the coffee
and frothed milk spouts. Adjust the length of
the milk spout. To move it nearer the cup,
simply pull it downwards (fig. 19).
8. Follow the instructions below for each
function.
Making cappuccino or macchiato
1. After attaching the milk container, turn the
froth adjustment knob on the milk container
lid between position 2 and 3 (fig.
20).
2. Press the CAPPUCCINO button on the control
panel. “CAPPUCCINO” is displayed, together
with a progress bar which fills gradually
as preparation proceeds. If the froth is not
satisfactory, turn the froth adjustment knob
towards 2 (= less froth) or towards 3
(= more froth) (fig. 20).
3. After delivering the frothed milk, the machine
automatically makes the coffee.
Please note!
• Ifduringdeliveryyouwanttostopmaking
milk or coffee, press the CAPPUCCINO
button twice.
• Attheendofdelivery,toincreasethequantity
of coffee in the cup, just press (within 3
seconds) the CAPPUCCINO button.
• Do not leave the milk container out of the
refrigerator for longer than strictly necessary.
The warmer the milk (41°F/5°C ideal), the
poorer the froth will be.
Making frothed milk (without coffee)
Proceed as described in the previous paragraph