Filter
Top Products
Minerals that are removed from water during the freezing cycle will eventually form a
hard scaly deposit in the water system. Cleaning the system regularly helps remove the
mineral scale buildup. How often you need to clean the system depends upon how hard
your water is or how effective your filtration may be . With hard water of 15 to 20
grains/gal. (4 to 5 grains/liter), you may need to clean the system as often as every 6
months.
1. Make sure that all the ice is off of the evaporator. If ice is being made ,wait for cycle
completion, then turn the machine “OFF” at the ICE/OFF/WASH selector switch.
2. Remove all ice from the storage bin .
3. Keep the ice maker connected to the water supply , Pour 200g. of Nickel-Safe Ice
Maker Cleaner Solution into the water trough. After about 5 minutes, initiate the wash
cycle at the ICE/OFF/WASH selector switch by the switch in the “WASH ”position.
The machine will run the Automatic Clean Mode.
4. Allow 30 minutes for proper cleaning. After cleaning, turn the machine “OFF” at the
ICE/OFF/WASH selector switch, Drain off the waste water to some container by drain
pipe in the left of the water trough.
5. Repeat steps 3 and 4 (without Ice Maker Cleaning Solution) to rinse the ice making
system 3 times.
Note: The use of the Ice Maker Cleaner Solution in the water bin during
the rinse is not needed.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect your hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
Discard the first batch of ice produced after cleaning..
6. Prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of
hot water (95º to 115º F). Wipe the entire bin inside and out, covering every wall
surface.
7. Fill a spray bottle with the sanitizing solution and spray all corners and edges making
sure to cover all surfaces with the solution.
8. Allow the solution to be in contact for at least 3 minutes, then dry.
9. Repeat step 5 to rinse the ice making system one more time.
10. Place the ICE/OFF/WASH selector switch to the “ICE ” position. The machine will
return to the regular ice making mode. Discard the first batch of ice.
Control Panel (rear of unit)
21