EdgeStar IB450SS Ice Maker User Manual


 
Problem Possible Cause Probable Correction
The icemaker is unplugged. Plug the ice maker in.
The fuse is blown. Replace fuse.
The icemaker power switch is
OFF.
Turn the ice maker power switch to ICE
(ON)
The machine won't
operate.
The ice storage bin is full of
ice.
Take away some ice cubes; make the
ice-full probe is free of ice.
The water supply tap is turn
off.
Turn on the water supply tap. The water doesn't
feed in after the ice
maker starts.
The water supply pipe is not
proper connected.
Reconnect the water supply pipe.
The condenser may be dirty. Clean the condenser.
The air flow to the ice maker
may be obstructed.
Check the installation.
Machine makes ice,
but bin does not fill
up with ice
The ambient temperature and
water temperature are high, or
it is near with some heat
source.
Check the installation.
A few water droplets are on the
door.
Under some conditions, humidity may
condense on the door. Consider moving the
unit or just be more careful when you open
the door.
Water is leaking out
the unit.
The water supply connection is
leaking.
Tighten fitting. See “Connecting the water
line”.
Check if the water supply pressure is below
0.05Mpa.
Check water supply--filter may be
restricted.
Cubes are partially
formed--are white
at the bottom.
Not enough water in the water
bin.
Check for a water leak at the water trough.
The feet are not leveled and
locked
Level and lock the feet. See Leveling the
Ice Maker.
Noise during
operation
Certain sounds are normal. See “Normal Sounds.”
The electricity is off. Reconnect the power supply line.
The icemaker stops
suddenly while
making ice.
The room temperature is out of
the stated range.
Cut off the electricity and let the ice maker
stop working until the temperature returns
within the stated range.
The body of the ice
maker is electrified
The ground line isn't in the
socket.
Use the correct plug and outlet.
Scale builds up
quickly inside the
machine.
The calcium level in the water
is too high.
Use a water-softening apparatus installed in
front of the water inlet valve.