Filter
Top Products
14
3. Slide the chimney through the hole in the shelf
before fixing it to the canopy.
Top Shelf
The top shelf only requires drilling if the hood is to be
installed with the air outlet turned upwards.
1. Use the cardboard template provided to mark the
hole position on the shelf.
2. Using the hole ‘B’ as a reference point, drill the
shelf along the centre axis for the chimney to pass
through.
Installation in the recirculation mode:
The cooker hood is specified for installation in the
recirculation mode with the charcoal filter fitted.
1. Draw a vertical line on the wall from the centre of
the cooking appliance, using a spirit level and
marking pen. This is to ensure the correct vertical
alignment of the appliance.
2. Using the cardboard template provided mark the
hole position (1) on the wall 100mm either side
of the vertical line ensuring they are level and
that the distance between the lowest point of the
hood and the cooking appliance beneath meet
the clearance requirements quoted in the
paragraph titled ‘Clearance Heights’.
3. Using the cardboard template mark the hole
positions (to be used for fixing the chimney)
30mm either side of the vertical line. The holes
must be drilled at a distance of (X) from the
horizontal line running through the centre of the
canopy fixing holes (1), which is calculated by
measuring the lenght of the chimney required for
the installation plus 15mm equal (Z).
4. Using a 8mm masonry bit, drill the holes for the
canopy and the fan assembly and insert the rawl
plugs provided ready for the fixing screws.
INSTALLING INSTRUCTIONS
ø120
ø150
100
100
ø 8
7
Z
X
48
20
650
S07_05
2
1 1