Filter
Top Products
NOTES
43
FITTING INTO THE SPACE BETWEEN
CABINETS
IMPORTANT: Ensure that the oven is
switched off at the wall before any further
work is carried out.
• Ensure the appliance is in front of the cabinet.
See Fig. 13.
• Take out all oven furniture before installation to
reduce the weight you need to lift.
• To place the appliance into the space between
cabinetry follow the procedure below:
• N.B. Two people will be required to carry out
the lifting procedure.
• Warning: Do not attempt to lift this appliance by
the handle(s).
Each person should squat either side of the
appliance.
Tilt the appliance so that your hands can support
the underside of the appliance.
Raise the appliance to the correct height.
Rest the rear underside of the appliance on the
mounting brackets while your hands support the
front.
The appliance can be pushed fully into the
space. Take care to avoid fouling the mains
lead.
Ensure the appliance is central and level.
• When the appliance is fully housed, screw the
stability screws (supplied with the appliance) into
the underside of the worksurface in the positions
indicated (see Fig. 14), taking care not to distort
thetrim. Itisadvisabletoturneachscrew
alternatively to avoid damaging the trim.
• Place the top trim flush with the edge of the
worksurface, with the cork spacers upover (see
Fig.15) and screw into position using the screws
supplied with the appliance.
• Replace the plinth board.
• Switch on the appliance and refer the user to the
operating instructions.
INSTALLATION INSTRUCTIONS
Fig.13
Fig.14
Fig.15