Electrolux 49002VMN Convection Oven User Manual


 
Display Description
There is a malfunction.
Residual heat indicator: a cooking zone is still hot.
The lock/child safety function is on.
The automatic switch-off is on.
ACTIVATING AND
DEACTIVATING THE HOB
Touch for 2 seconds to activate the
hob. Touch
for 1 second to deactivate
the hob.
ACTIVATING AND
DEACTIVATING THE OUTER
RINGS
You can align the heating surface with the
dimension of the cookware.
To activate the outer ring, touch the sen-
sor field
or . The indicator comes
on. For more outer rings touch the same
sensor field again. The next indicator
comes on.
To deactivate the outer ring, do the same
steps again. The indicator goes out.
HEAT SETTING
Touch to increase the heat setting.
Touch
to decrease the heat setting.
The display shows the heat setting. Touch
and at the same time to deactivate
the cooking zone.
AUTOMATIC HEAT UP
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the graphic), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function:
1.
Touch . comes on in the dis-
play.
2.
Touch again and again until
comes on in the display.
3.
Immediately touch again and
again until the necessary heat setting
comes on. After 3 seconds
comes
on in the display.
To stop the function touch
.
1
2
3
4
5
6
7
8
9
10
11
0
123456789
POWER MANAGEMENT
Operating both ovens and the four hob
zones at the same time can activate the
power management system, which will
deactivate one or more of the hob heat-
ing zones. This is a power regulation with-
in the appliance to prevent a circuit over-
load
TIMER
Use it to set an automatic switch-off time
for a cooking zone.
1.
Set the cooking zone. Touch again
and again until the indicator for the
necessary cooking zone comes on.
You must set the cooking zone
before you activate the timer.
2.
Set the heat setting for the cooking
zone. You can also set it after you ac-
tivate the timer.
3.
To activate the timer or change the
set time, touch + or - on the hob con-
trol panel. The maximum time you
can set is 99 minutes.
The indicator of the cooking zone
flashes slowly. The timer starts to
count down.
10
www.aeg.com