Filter
Top Products
TO REMOVE THE OUTER
1.Open the oven door slightly to gain access to
the two cross head screws on the top of the
oven door.
2.Loosen the two screws using a Pozidrive
screwdriver.
3.Holding the door glass securely in place with
one hand remove the screws and washers
with the other hand.
The screws and washers retain the trim on
the top of the grill door. Note the position of
the trim on the door.
4.Holding the door and glass with one hand,
pull towards you and slightly lift the door
glass with the other hand to disengage the
panel from the location point at the bottom of
the door. Gently release the door to close it.
5.Clean the outer and inner glass using hot
soapy water or Hob Brite. Should the inner
face of the outer door glass be heavily soiled
it is recommended that soapy water with a
high concentration of soap is used. To
prevent streaking a glass cleaning spray may
be applied and the glass polished with a soft
cloth. Ensure that all parts are well rinsed
and thoroughly dry before attempting to
replace the outer door glass.
6. DO NOT use abrasive cleaning materials or
scourers on the outside of the appliance as
damage will occur.
Any spillage on the stainless steel finish must
be wiped off immediately.
Stainless Steel cream cleaners are
abrasive and should be avoided as they
may dull the surface finish.
To prevent streaking on stainless steel
models finish with a soft cloth.
GLASS
If the door glass panel becomes
chipped or has deep scratches the
glass will be weakened and must be
replaced to prevent the possibility of
the panel shattering. Please contact
your local Service Force Centre who
will be pleased to advise further.
Grill Door Trim
43