Filter
Top Products
TO REMOVE THE INNER GLASS
1. Fully open the oven door.
2. Firmly grasp the rear edge of the inner glass
panel with both hands.
3. Push the glass panel towards you until it clears
the hinge location points at the rear.
4. With one hand, carefully lift the glass panel to
disengage it from the location points under the
handle. (With your other hand, hold the
outer door to ensure it does not spring
shut on removing the inner panel).
5. Close the oven door.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner door glass panels using a soft cloth
and hot water to which a little washing up liquid has
been added. If the inner panel is heavily soiled,
Hob Brite may be used. Do not use abrasive
cleaning materials on the door glass. Ensure that
all parts are well rinsed and thoroughly dried before
attempting to replace the glass.
TO REPLACE THE INNER GLASS
PANEL
1. Holding the glass panel in your right hand fully
open the oven door with your left.
2. Gently ease and push the glass into the
location points under the handle before
lowering and sliding the glass into position
under the hinge location points at the rear.
Ensure the glass is properly located and that the
text 'This way up' is facing towards you and at the
top edge of the door.
33
Do not clean stainless steel outer
panels (where fitted) with Hob Brite as
damage to the finish will occur. See
cleaning instructions for stainless steel
models on page 31.
Do not attempt to use the oven without
the glass being in place.
If the door glass panel becomes
chipped or has deep scratches the
glass will be weakened and must be
replaced to prevent the possibility of
the panel shattering. Please contact
your local Service Force Centre who
will be pleased to advise further.
Hinge location
point
Hinge
location point