Filter
Top Products
10 electrolux Installation
EN
Fixing the frame
• Loosen the two screws fastening the
lower chimney and remove this from
the lower frame.
• Loosen the two screws fastening the
upper chimney and remove this from
the upper frame.
If you wish to adjust the height of the
frame, proceed as follows:
• Unfasten the eight metric screws join-
ing the two columns, located at the
sides of the frame.
• Adjust the frame to the height re-
quired, then replace all the screws
removed as above.
• Insert the upper chimney stack from
above, and leave it running free on the
frame.
• Lift up the frame, fi t the frame slots
onto the screws up to the slot end
positions.
• Tighten the two screws and fasten
the other two screws provided with
the hood.
Before tightening the screws completely
it is possible to adjust the frame by tur-
ning it. Make sure that the screws do
not come out of their seats in the slotted
holes.
• The frame mountings must be secure
to withstand the weight of the hood
and any stresses caused by the oc-
casional side thrust applied to the
device.
On completion, check that the base is
stable, even if the frame is subjected
to bending.
• In all cases where the ceiling is not
strong enough at the suspension
point, the installer must provide
strengthening using suitable plates
and backing pieces anchored to the
structurally sound parts.
2
2
1
1