Filter
Top Products
Use electrolux 13
EN
Touch
control
Basic functions Indicator lights
Dual Function
L
When briefl y pressed it switches the lighting
system on and off.
Touch control
unlit
Lights off
When pressed for 2 seconds it starts the
lighting system in “courtesy light” mode.
The lamps are fed at a reduced power of
approximately 5W. Such function can be
stopped by pressing the touch control for 2
seconds or just by pressing it shortly in order to
return to the normal lighting mode. In courtesy
light mode the touch control is not lit.
Touch control lit Lights on
Touch control
unlit
Courtesy light on
T1
When pressed the motor is stopped, regardless
of the speed it is set to.
Touch control lit Motor on
Touch control
unlit
Motor off
T2
When pressed the motor is set to the fi rst speed
Touch control lit
T3
By a brief pressing the motor is set to the second
speed.
Touch control lit Second speed on
By pressing the touch control for approximately
2 seconds the Delay function is enabled, i.e
delayed shutdown of the appliance ensuring
a complete elimination of the residual odours.
This function can be activated at OFF-position
and at 1°, 2° and 3°speeds. It can be stopped
in advance by pressing any of the touch
controls (T) with the exception of T3. The Delay
function works according to the following
scheme:
1°speed / OFF = 20 minuets
2°speed = 15 minutes
3°speed = 5 minutes
Flashing touch
control
Delay function on
T4
When pressed the motor is set to the third speed Touch control lit
T5
When pressed the motor is set to the intensive
speed timed to 5 minutes. At the end of 5
minutes of intensive speed the hood starts again
at the speed it was set to previously. In case the
hood is set to the intensive speed directly from
OFF-state it will then start from the fi rst speed
after 5 minutes of intensive speed.
Touch control lit
F
When pressed for 4 seconds it resets the fi lter
alarm signal indicated by fl ashing of the touch
control T1. This procedure can be carried out
only when the motor is stopped.
Touch control lit Metal grease fi lters saturation
alarm. Metal grease fi lters need
to be washed. The alarm starts
up after 100 working hours.
Flashing touch
control
Charcoal fi lter saturation
alarm. Charcoal fi lter has to
be replaced and metal grease
fi lters washed. The alarm
starts up after 200 working
hours. (Activation; check the
paragraph “Charcoal fi lter”)