Filter
Top Products
Installation electrolux 11
EN
Connection in Ducting Version
When installing the ducting version,
connect the hood to the chimney using
either a fl exible or rigid pipe ø 150 or
120 mm, the choice of which is left to
the installer.
• To install a ø 120 mm air exhaust con-
nection, insert the reducer fl ange 9 on
the hood body outlet.
• Fix the pipe using the pipe clamps 25
provided.
• Remove charcoal fi lters, if present.
Connection in Recycling Version
• Fix the connection 15 to the frame
using the 4 screws provided.
• Fix the fl ange 10 to the lower opening
of the connection 15.
• Connect the hood air outlet to the
fl ange in the lower part of the junction
using a rigid or fl exible ø 150 tube (by
installer’s choice).
• Ensure that the charcoal fi lters have
been fi tted.
Chimney assembly / Mounting
the hood body
• Position the upper chimney section
and fi x the upper part to the frame
using the 2 screws 12c (2,9 x 6,5)
provided.
• Similarly, position the lower chimney
section and fi x the lower part to the
frame using the 2 screws 12c (2,9 x
6,5) provided.
Before fi xing the hood body to the fra-
me:
• Remove the grease fi lters from the
hood body.
• Remove charcoal fi lters, if present.
• From below, use the 4 screws 12f
(M6 x 10)provided to fi x the hood
body to the frame.
9
ø 150
ø 120
25
25
15
10
12c
12c
12f
1