Filter
Top Products
21
Installing the Cooker
Gas connection
Read these points before connecting to the gas supply:
• The cooker inlet connection point is the inlet to the regulator or LP test point adaptor. This connects to the
flexible hose fitted to the appliance. The appliance must be installed using the hose supplied.
Operation on NG/SNG
Read these points about operation on NG/SNG and look carefully at the diagram:
• The appliance regulator which is provided MUST
be fitted and positioned so that the pressure nipple
and adjuster screw are accessible.
• The arrow showing the direction of the flow MUST
be pointed correctly.
• Connect the gas supply to the 1/2” BSP internal
thread inlet of the regulator.
• The flat fibre washer which is provided in the
regulator parts MUST be used when making the
gas connection.
Operation on SNG
• If the cooker is to be used with SNG, then the grill burner MUST be modified by the replacement of the
shutter which fits into the throat of the grill burner.
• You can buy the kit for this modification from your nearest spare parts stocklist.
1. Remove the control panel. Remove the existing NG shutter and fit the shutter in the throat of the grill burner.
2. Align the hole in the shutter with the hole in the grill burner and secure the short screw.
Operation on Propane
An inlet fitting with pressure test point is provided. Orient the fitting so that gas flows in the direction of the
arrow marked on the fitting. Use the sealing washer to connect the fitting to the flexible hose. Connect the gas
supply to the 1/2” BSP internal thread inlet of the fitting.
Washer
(P/No. 115-009-011)
NG Regulator
(P/No. 294-001-026)
Internal
Flange
Gas Flow