Filter
Top Products
14
The rinse-aid
The rinse-aid ensures brilliant crockery and also helps it to dry. It is automatically
dosed in during the hot rinsing cycle. The storage compartment built in to the inside
of the door can hold about 110 ml of rinse-aid, which will be sufficient for between
16 and 40 dishwashing programmes, according to the dosage setting.
Filling up the rinse-aid
1. Open the container by turning the lid
(A) anticlockwise.
2. Add the rinse aid until the container is
completely full. The indicator (B) will be
completely dark.
Ensure that the lid is closed after every
refill.
Top up with rinse aid when the indicator (B)
becomes clear.
Clean up any rinse aid spilt during filling with
an absorbent cloth to avoid excess foaming
during the next wash.
Attention! Do not put liquid detergent in
the rinse aid compartment.
Adjusting the dose
The correct dosage of the rinse-aid should
be regulated on the basis of the shine and
drying results.
For this purpose, set the quantity of liquid
by means of the six-position selector (C)
located on the inside of the filler opening
(minimum quantity is position 1,
maximum quantity is position 6).
Use the tip of a screwdriver to rotate the
selector. If drops of water or white marks
remain on the crockery after it has been
washed, increase the dosage. If the
crockery comes out with whitish, sticky
streaks, reduce the dosage.
BR01
BR03
BR02
152983 79/2 8-02-2002 17:22 Pagina 14