Filter
Top Products
37
Adjusting the worktop
You can move the worktop forward or backward by
25 mm in order to align the machine with other
kitchen units.
Simply unscrew the two front retaining screws,
move the top to the required position and then
retighten the screws.
Fitting under a counter (kitchen worktop or sink)
By removing the machine’s worktop, you can
install it under a close fitting sink unit or a pre-
existing top, providing the dimensions of the recess
correspond to those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by
unscrewing the two front retaining
screws, pull from the front and slide
out the rear slots, lifting the worktop.
Insert the machine after adjusting height and
levelling with the adjustable feet. When inserting the machine, ensure that the water
inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the levelling
spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the
machine is perfectly level.
IN02
820
570-600
450
IN04
Installation and connection instructions
IN06
IN07
152983 79/2 8-02-2002 17:22 Pagina 37