Filter
Top Products
12
Prior to using for the first time
1.Set the water softener
2.Fill up with special salt for water softeners
3.Fill up with rinse aid
3 If you wish to use “3in1” detergent, please do the following:
– First read the section “Using 3in1 detergents”.
– Switch on the dishwasher, go to option 3 IN 1, change value to ON
(see section “ Adjusting an option/setting”); symbol lights up in
the symbol line. As a result
– there is no need to fill up with special salt or rinse aid.
– there is no need to set the water softener.
– there is no need to activate/deactivate the rinse aid inflow.
– Before the start of the dishwashing cycle put 3in1 detergent in the
detergent dispenser.
Setting the water softener
The water softener must be set manually and electronically:
3 To avoid scale deposits on the dishes and in the dishwasher, the dishes
must be washed with soft water, i.e. water with a low lime content. The
water softener must be set according to the table to the water hard-
ness in the area where you live. Your local water company will be able
to give you information about the water hardness in your area.
The dishwasher must be switched off.
Setting manually:
1.Open the dishwasher door.
2.Remove the lower basket from the
dishwasher.
3.Turn water hardness dial on the left
wall of the dishwasher interior to O
or 1 (see table).