Filter
Top Products
26
Starting a dishwashing cycle
1.Check that the spray arms can turn freely.
2.Turn the water tap on fully.
3.Close the door.
4.Press the ON/OFF button.
5.Using the direction buttons ( or ) select the desired cycle.
The name of the selected dishwashing cycle will flash. To the right of
the name the estimated length of the programme is displayed.
6.Press the OK/START button.
The selected dishwashing cycle will start. In the text line in the display
you can see the name of the current stage in the programme. Next to
this you can see the estimated time remaining in minutes.
Using the OPTION button you can briefly display the name of the dish-
washing cycle in the display.
3 A dishwashing cycle can only be started from the Programmes menu.
3 During the dishwashing cycle, the remaining time shown in the display
may be adjusted according to the size of the load, degree of soiling, etc.
If the dishwashing cycle does not start:
If after pressing the OK/START button the cycle does not start and a
message appears in the display, (REFILL RINSE AID, REFILL SALT or
PLEASE CLOSE DOOR):
• Follow the instructions in the message.
After the problem has been remedied, the cycle starts automatically.
3 With the messages REFILL RINSE AID or REFILL SALT you can neverthe-
less start the cycle by pressing the OK/START button again.
3 While a dishwashing cycle is running, you cannot make changes to op-
tions or settings.
3)When using this cycle, only load the dishwasher half full.
4)During the final rinse, the temperature is increased to 68° for 10 minutes to disinfect e.g. ba-
bies’ bottles.
5)Test programme for Test Institutes
6)This cycle does not need any detergent.