Filter
Top Products
27
WARNINGS
· This appliance must be installed by a
qualified electrician/competent person.
Safety may be impaired if installation is
not carried out in accordance with these
instructions.
· This appliance must be earthed.
· Do not remove the screws from the earth
tab extending from the oven mains
terminal block (Fig. 1).
· Before connecting the appliance make
sure that the voltage of your electricity
supply is the same as that indicated on
the rating plate. This is situated on the
lower front frame of the appliance and can
be seen upon opening the door.
Alternatively the rating plate may also be
found on the back or top of some models
(where applicable).
· Do not alter the electrical circuitry of this
appliance.
THINGS TO NOTE
· This appliance is designed to be fitted between
cabinets with the recommended dimensions as
shown Fig. 2 & 3.
· If there is an existing housing unit it must be
removed.
· The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
· This appliance must not be installed on the wooden
base board.
· Enquiries regarding the installation of the cooker
point, if required, should be made to your Regional
Electricity Company to ensure compliance with
their regulations.
· The appliance socket switch should be outside the
cabinet but within 2m of the appliance to make it
accessible to switch off the appliance in case of an
emergency.
· To protect the hands, wear gloves when lifting the
oven into its housing.
Do not lift the appliance by the handles.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried out
before the appliance is connected to the mains supply
and re-checked after fitting.
INSTALLATION INSTRUCTIONS
Fig.1
Fig. 3
Fig. 2