Filter
Top Products
11
Touch
control
Basic functions Indicator lights
Dual Function
L
When briefly pressed it switches the light-
ing system on and off.
Touch control unlit Lights off
When pressed for 2 seconds it switches
the electroluminescent lighting on
and off. This function is independent
from the basic functions of the control
unit. It is therefore possible to switch on
simultaneously the hood lighting and the
electroluminescent lighting. During the
electroluminescent lighting mode the
touch control is unlit.
Touch control unlit Lights off
Touch control lit Lights on
Touch control unlit Electroluminescent lighting on
T1
When pressed the motor is stopped, regard-
less of the speed it is set to.
Touch control lit Motor on
Touch control unlit Motor off
T2
When pressed the motor is set to the first
speed
Touch control lit
T3
By a brief pressing the motor is set to the
second speed.
Touch control lit Second speed on
By pressing the touch control for approxi-
mately 2 seconds the Delay function is
enabled, i.e delayed shutdown of the
appliance ensuring a complete elimina-
tion of the residual odours. This function
can be activated at OFF-position and at
1°, 2° and 3°speeds. It can be stopped in
advance by pressing any of the touch
controls (T) with the exception of T3.
The Delay function works according to
the following scheme:
1°speed / OFF = 20 minuets
2°speed = 15 minutes
3°speed = 5 minutes
Flashing touch
control
Delay function on
T4
When pressed the motor is set to the
third speed
Touch control lit
T5
When pressed the motor is set to the boost
option timed to 5 minutes. At the end of 5
minutes of boost option the hood starts again
at the speed it was set to previously. If the
hood is in the OFF-position and the boost
option is selected, after 5 minutes the speed
is reduced to setting 1 (T2).
Touch control lit
F
When pressed for 4 seconds it resets the filter
alarm signal indicated by flashing of the touch
control T1. This procedure can be carried
out only when the motor is stopped.
Touch control lit Metal grease filters saturation alarm.
Metal grease filters need to be washed.
The alarm starts up after 100 working
hours.
Flashing touch
control
Charcoal odour filter saturation alarm.
Charcoal filter has to be replaced and
metal grease filters washed. The alarm
starts up after 200 working hours. (Ac-
tivation; check the paragraph “Charcoal
filter”)