Filter
Top Products
12
with the appliance’s functions and
with the recommendations given.
CE This appliance is in accordance
with the directive BT 73/23
§ Electricity safety norms EN 60335-
1 (August 1995 - Safety for
electrical household appliances
and similar – General Norm) and
EN 60335-2-15 (April 1996 –
Specific Norms concerning heating
liquids appliances).
§ Directive EMC 89/336 in
conformity with the following
norms:
- 55014-1
- 55014-2
- 61000-3-2
- 61000-3-3
4. INSTRUCTIONS FOR THE
FIRST USE
FILL UP THE WATER RESERVOIR
· Push the cabinet locking button
(E/1).
· Take the coffee machine out of
the housing using the special
telescopic runners (E/2).
· Fill up the water reservoir (G)
situated on the left side of the
appliance with 2,5 litres of water.
· Push the coffee machine back into
the housing (F/1) and push the
locking button (F/2).
· The hardness of the water:
- Before filling up the water
reservoir, make sure that the Brita
filter (A-17) has been soaked for
at least 30 min. in cold water
(please follow the instructions
indicated on the filter packaging).
After that, insert the filter into the
reservoir (see chapter 12.
Installation “Water Connection”).
- If the machine will not be used for
long periods, change the water in
the reservoir and empty the boiler
by making the machine dispense
about half a litre of water (see
chapter 8. Hot water).
FILL UP THE COFFEE BEANS
CONTAINER
· Push the cabinet locking button
(E/1).
· Take the coffee machine out of
the cabinet using the special
telescopic runners (E/2).
· Put into the coffee container,
situated on the right side of the
appliance, about 200 gr. of coffee
beans (H).
· Push again the coffee machine
into its relative seat as before
(F/1) using the special runners.
· Push the locking button again
(F/2) so that the machine will be
secured in the housing.
STARTING PROCESS
· Switch the coffee machine on by
pushing the ON button (B-20).
The red warning light (B-25)
indicates the appliance is
connected to the mains supply
(lamp illuminated = ON/ lamp out
= OFF).
· Set the machine to dispense hot
water (see paragraph 7. Hot
water) and wait until the air
contained in the boiler has
completely passed through the
steam pipe (A-2) and water