Filter
Top Products
8
Use and Care
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE HOOD.
For satisfactory use of your hood, become familiar with the various functions of the
hood as described below
Motor OFF button
ON button and
motor suction
power selection
button 1, 2, 3, 1,....
Suction power
1 LED, this led
is ON when
suction power
1 is selected.
Suction power
2 LED, this led
is ON when
suction power
2 is selected.
Suction power
3 LED, this led
is ON when
suction power
3 is selected.
Intensive
Suction power
LED, this led is
ON when the
intensive
suction power
is selected.
Intensive
Suction power
button - this
suction power
will function for
10 mins. then
the hood set
again the
preselected
speed
Light OFF button
Light ON button
Figure 7
Grease Filter Saturation LED
The Suction power 2 LED is marked with an F. This LED will flash to remind you when the grease filter needs to be cleaned
after 40 hours use. Follow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned, reset
the reminder by pressing Motor OFF button for about 3 seconds until you hear the signal (beep).
Should the Suction power 3 LED starts to flash then push ON and power selection button and the Intensive Suction power
button simultaneously for more than 3 seconds to stop flashes.
Operating Instructions
The blower should be turned on for about 5 minutes before cooking in order to establish air currents upward through the hood.
Use the low speeds for normal use and the higher speeds for strong odors or fumes.
Minimize cross drafts which will reduce the effectiveness of the hood.