Filter
Top Products
4
4807
5
4872
1000-
1330
280-
650
2
2
8
0
-
2
6
0
0
2
0
2
0
-
2
3
5
0
5
8
0
-
8
8
0
8
3
0
-
1
1
3
0
1730-
2050
1
5
0
0
-
1
8
3
0
1
2
3
0
-
1
5
3
0
DEAD
LOAD
A
B
0107
69
11
Notice
Date
Page
01201138
INSTRUCTION
HANDBOOK
11. Machine
operation
Load cell
Install the new load cell as indicated by ar-
row on side of load cell !
The dead load selector
The dead load selector, located in the scale
unit, is used for setting the machine’s "dead
load".
The dead load is the load (weight) to which
the load cells are subjected before any load
is placed in the wash drum. The dead load
selector is set before the machine leaves the
factory, and its setting should not normally
be changed. The selector should be set to
580-880 kg (machines 250-350-500) or 830-
1130 kg (machine 650).
If calibration of the weighing equipment
should fail, one possible cause can be that
this selector is incorrectly set.
To replace a load cell
• Use a suitable jack to lift under the frame
at the corner where the load cell is to be
replaced.
• Insert a suitable object as a chock be-
neath the frame, to remove risk of injury
and machine damage.
• Disconnect the load cell cable at the
scale unit.
• Remove the screws (A).
• Remove (B).
• Remove the faulty load cell and fi t the
new, assembly is reverse of disassembly.
Fig.
4
Fig.
5