Filter
Top Products
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop Switch
TM
.
PREPARATION
START HERE
PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS
■■
Identify locations for the dispenser
faucet, tank and filter (if applicable).
■■ Check to make sure there is proper
clearance (see chart at left) for
dispenser handles to be fully opened.
■■ Check to make sure counter is not
too thick (see chart at left).
■■ Make sure there is a grounded
electrical outlet under the sink.
■■ Turn off water supply.
■■ If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
■■ Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
■■ Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
1
A
B
If you have to drill through sink or
countertop,you may need to rent or purchase
the appropriate tools.
Consult a professional before drilling into
a surface other than stainless steel.
C
Required minimum from
center of hole to wall
Maximum counter
thickness (depth)
What if you don’t have a sprayer hole or
don’t want to use it?
■■ Many homeowners replace the soap
dispenser in their sink with an instant
hot water dispenser.
■■ If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with a
hole saw for stainless steel, or you can
use a hole punch.
Required Hole Size
1
1
⁄4" - 1
1
⁄2"
Dependent on model
HC-View-SS...... 2
5
⁄8"..........................3"
H-View-SS ........ 2
5
⁄8"..........................3"
HC-Wave-SS .... 2
5
⁄8"..........................3"
H-Wave-SS ...... 2
3
⁄8"..........................3"
H990-SS .......... 1
1
⁄4"..........................3"
H770-SS .......... 2" ............................
3
⁄4"
COMPONENTS IN THIS PACKAGE
Metal
Mounting Plate
Fiber Gasket Mounting Screw
H770-SS
Tan k
Snap-Connect
Fitting (3 pieces)
3/4" Screws (2)
Tan k
Semi-Circular
Mounting Plate
Rubber Gasket
H990-SS
Wing Nut
Tan k
3/4" Screws (2)
Snap-Connect
Fitting (3 pieces)
HC-View-SS
H-View-SS
H-Wave-SS
HC-Wave-SS
3/4" Screws (2)
Small Steel FiberRubber Large Steel
Washers
2-1/4"
1-5/8" 1-5/8"
2-1/4"
3/8" Tube
Brass Nut/Ferrule/
Tube Insert
Quick Connector
Snap-Connect
Fitting (3 pieces)
Tan k
3/4" Screws (2)
Snap-Connect
Fitting (3 pieces)
Extension & Star Nut
Extension & Star Nut
Small Steel FiberRubber Large Steel
Washers
2-1/4"
1-5/8" 1-5/8"
2-1/4"
4
5