Filter
Top Products
Electric Shock Hazard: Using an ungrounded or improperly connected
appliance can result in serious injury or death from electrical shock.
Property Damage: To avoid water damage, replace any loose or split tubing.
Periodically inspect the unit for any signs of leakage and immediately remove from
service any unit suspected of leaking.
Personal Injury: This tank is a non-pressurized tank.DO NOT modify this system.
DO NOT close vent tube or connect other type dispensers or valves to the tank.Use only
the InSinkErator dispenser faucet supplied. Use only parts provided.Contact an
authorized InSinkErator Service agent for repairs or replacement components.
Dispenser: 3-year warranty
Stainless Steel Tank: 3-year warranty
Covers all replacement parts and labor to correct defects in material or workmanship in the
dispenser system, excluding the replaceable filter cartridge, for the full warranty period from the
date of installation in your home. If warranty service is required during the warranty period,
contact an authorized InSinkErator service agent to replace or repair the unit in your home at no
cost to you. If your dispenser is replaced rather than repaired, the warranty on the new unit
shall be for the duration of the remaining portion of the original dispenser’s warranty. Note:
Warranty is determined by unit serial number and/or date of installation. Purchase or installation
receipt may be required to verify warranty status. When service is required, and for the location
of your nearest factory authorized service center, call toll free 1-800-558-5700.
The foregoing warranty does not apply to damage or inoperation resulting from accident,
alteration, misuse, abuse, improper installation, installation not in accordance with these
instructions or local electrical and/or plumbing codes. We do not assume any responsibility for
consequential damage. Install using genuine InSinkErator
®
manufactured components only.
Use of non InSinkErator components will void your warranty.
Some states do not allow limitations on how long an implied warranty lasts, or the
exclusion or limitations of incidental or consequential damages, so the above limitations or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
This appliance must be grounded. This instant hot water dispenser is equipped with a cord that
has a grounding conductor and a grounding pin.The plug must be connected to an appropriate
outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Do not modify the plug provided with the appliance – if it will not fit the outlet, have a proper outlet
installed by a qualified electrician. Check with a qualified electrician or serviceman if you are in
doubt as to whether the instant hot water dispenser is properly grounded.
WARRANTY INFORMATION
Fire Hazard: To minimize possibility of fire,DO NOT store flammable items such as
rags, paper or aerosol cans near the tank.DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
An instant hot water dispenser, like any water heater, has a limited life and will eventually fail.
To avoid possible property damage and personal injury, this instant hot water dispenser
should be regularly examined for leakage and/or corrosion and replaced when necessary. A
drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used
in those applications where any leakage could cause property damage. To check for
corrosion, examine the appearance of the dispensed water in a clear glass once every three
(3) months. If there is any discoloration or rusty appearance, unplug and drain unit as
described in the Seasonal Storage/Drainage section on page 12 of this manual. If the water
discoloration remains after draining and refilling unit, discontinue use and contact an
authorized InSinkErator service agent.
Scalding Hazard:The faucet dispenses near-boiling
(212ºF) water which can instantly cause scalds or
burns. Use care when operating this appliance.
Property Damage: Join remaining tube
to cold water supply only.
Property Damage: Join remaining tube
to cold water supply only.
B
■■ Turn on the cold water supply.
■■ Depress the dispenser’s HOT
handle and hold it until water flows
from the spout (approximately 1 to
2 minutes).
■■ Run the water for at least 2 minutes to
flush lines (both the hot and cold
handles independently if applicable).
A
A
6
■■
Check all connections to ensure they are
tight
and that there are no leaks.
■■
Plug in instant hot water tank.
Water will be cold at first.
Allow 12-15 minutes for water to reach
target temperature.
Gurgling or hissing is normal during the
initial heating cycle.
5
■■
Install a T-fitting (not included) onto the
cold water supply line.
■■
Install dedicated water control valve with
3/8" compression fitting.
■■
At the end of the white 3/8" tube from the
quick-connector, slide the supplied brass
nut and ferrule over the tube and then push
in the brass tube insert.
■■
Insert the white 3/8" tube into the 3/8"
compression fitting and tighten.
HC-View/HC-Wave
■■ Install a T-fitting (not included) onto
the cold water supply line.
■■ Install dedicated water control valve with
1/4" compression fitting (not included).
■■ At the end of the copper 1/4" tube,
slide the brass nut and ferrule provided
with the control valve over the tube.
■■ Insert the copper tube into the 1/4"
compression fitting and tighten.
H-View/H-Wave/H990/H770
A
Property Damage: A standard grounded outlet within
30" of the dispenser is required under the sink. Do
not use an extension cord set with the dispenser.
Brass Nut
Plastic
tube
Ferrule
Brass Inser
tube
Copper
Brass Nut
Ferrule
FINAL WATER CONNECTION
FILL TANK & THEN CONNECT POWER
10
11