Filter
Top Products
11
To Convert Gas Pressure Regulator
1. Turn manual shutoff valve to the “closed” position.
2. Remove grates.
3. Lift the cooktop by both front corners until the side support
rods snap into position.
4. Locate the gas pressure regulator.
IMPORTANT: Do not remove the gas pressure regulator.
5. With a flat-blade screwdriver, remove the brass cap and flip
the brass cap over so that “LP” is visible.
6. Reinstall the cap and tighten with the flat-blade screwdriver.
To Convert Surface Burners
1. Remove grates from cooktop
2. Lift the cooktop by both front corners until the side support
rods snap into position.
3. Remove the screws that hold each dual burner.
4. Lift each burner and slip it back to remove it.
5. Set them aside.
6. Locate LP gas orifice spuds for top burners in the bag
containing literature included with the range. Four LP gas
spuds are stamped “67.”
7. Remove Natural gas orifice spuds from the valve using a
³⁄₈" (0.95 cm) combination wrench.
8. Install LP gas orifice spuds in the valves.
9. Place the Natural gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
10. Replace grates.
To Convert Oven Burner
1. Open the oven door and remove oven racks, oven tray, flame
spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner air
shutter.
A.To range
B.Manual shutoff valve “closed“ position
C.Gas supply line
A.Gas pressure regulator
A.Brass cap
A.Cap
A
B
C
A
NAT
A
LP
A
A.Dual burner screws
A. Orifice spuds
B.Valves
A. Air shutter
A
B
A
A