Filter
Top Products
Australia
A inner burner cap, B outer burner cap
C inner burner head D outer burner head
E Wok burner base
When re-assembling the Wok burner, turn over the large
base ring and find the ‘D’ shaped area:
Turn the head until the ‘D’ matches the one on the
burner base. Turn the head over and place it on the
burner base.
To fit the small inner burner, find the larger electrode
notch in the burner rim. Line this up with the white
ignition electrode and place the inner burner on the
large base ring.
A electrode notch B ignition electrode
Now fit the two burner caps, ensuring that they are
seated properly.
Recommended cleaning materials are hot soapy water,
a moistened soap pad, cream cleaner or a nylon scourer.
Before you remove any of the grill parts for cleaning.
ensure that they are cool, or use oven gloves.
The grill pan and grill pan carriage can be easily
removed for cleaning.
The grill pan and grid should be washed in hot soapy
water, or using our recommended Rangemaster
cleaning solution.
After grilling meats or any foods that soil, leave to soak
for a few minutes in the sink immediately after use.
Stubborn particles may be removed from the grid by
using a nylon brush.
When refitting the grill pan, ensure that the wide rim is
at the front:
Avoid using any abrasive cleaners, including cream
cleaners, on brushed Stainless Steel surfaces. For best
results, use a liquid detergent.
The control panel and knobs, and doors, should only be
cleaned with a soft cloth wrung out in clean hot soapy
water. After cleaning, polish with a dry cloth.
The Main oven has panels which have been coated with
a special enamel that partly cleans itself. This does not
stop all marks on the lining, but helps to reduce the
amount of manual cleaning needed.
The Cook & Clean panels work better above 200°C. If
you do most of your cooking below this temperature,
occasionally remove the panels and wipe with a lint
free cloth and hot soapy water. The panels should
then be dried and replaced and the oven heated at
200°C for about one hour. This will ensure that the
Cook & Clean panels are working effectively.
Don’t use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
Some of the lining panels can be removed for cleaning.
You will need to remove the shelves before removing
the panels.
Each side of the oven is fixed with four fixing screws.
You don’t have to remove the screws to remove the
oven linings. Simply lift each side panel upwards and
they will slide off the screws. Then pull them forwards:
Once the linings are removed, the oven enamel interior
can be cleaned.