Filter
Top Products
Australia
When fitting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of the
door, and proceed round the door snapping in each hook
in turn.
Pull the cooker forward to gain access to the cover box at
the rear of the left hand oven. Remove the screws securing
the cover and lift clear. Pull off all the leads to the generator,
noting their positions. Slacken the two screws holding the
generator to the cooker and remove the generator.
Fit the new generator to the cooker and replace the leads,
referring to the wiring diagram. Re-assemble in reverse
order. Check ignition performance.
Open the oven door and remove the oven furniture.
Unscrew the two thermostat phial fixing screws (see section
7). Remove the fixings that secure the inner back to the
oven rear:
Lift the removable panel away. Re-assemble in reverse
order, ensuring that the retaining fixings are fully tightened.
Pull the unit forward to access the cover boxes at the rear of
the appliance. Remove the fixings that secure the cover and
lift it clear. Remove the fan wiring, noting the connection
positions. Remove the inner back as detailed in section
22. Hold the fan blades and undo the centre nut (left hand
thread), brass washers, fan blade and Circlip. Undo the
fixings that retain the fan and remove it from the cavity rear.
Fit the replacement and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.
Remove the oven inner back as detailed in section 22.
Remove the fixings that secure the element within the oven
and lift the element away carefully.
Disconnect the leads and connect to the replacement
element. Re-assemble the parts in reverse order. Check that
the oven operates correctly.
Remove the grill pan from the grill chamber. From
inside the grill compartment, remove the enamelled
front shield from the grill roof, and the two screws and
washers.
Remove the two screws and washers securing the grill
element front support. Remove one screw from each of
the grill elements and withdraw the grill element from
the grill chamber.
Disconnect the leads and connect to the replacement
elements. Re-assemble the parts in reverse order. Check
the operation of the grill.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear
of the unit. Remove the fixings that secure the cover and lift
it clear.
Remove the two screws ‘A’ and allow the plate to drop
down.