Filter
Top Products
Cooktop & Installation Manual
Model COGB ENGLISH
14
Electrical Requirements
General Information
This appliance must be supplied with the proper
voltage and frequency and connected to an individual,
properly grounded branch circuit, protected by a
circuit breaker or fuse having amperage as noted on
the rating plate. We recommend you have the
electrical wiring and hookup of your cooktop
connected by a qualified electrician.
After installation, have the electrician show you where
your main cooktop disconnect is located. Check with
your local utilities for electrical codes which apply in
your area. Failure to wire your cooktop according to
governing codes could result in a hazardous
condition.
If there are no codes, your cooktop must be wired and
fused to meet the requirements of the National
Electrical Code, ANSI/NFPA No. 70 - Latest edition.
You can get a copy by writing:
National Fire Protection Association
Battery march Park
Quincy. MA 02269
In Canada your cooktop must be wired and fused to
meet the requirements of the Canadian Electrical
Code.
Be sure the installation of this product in a mobile
home conforms with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280.
If this standard does not apply, you must follow the
standard for Manufactured Home Installations, ANSI
A225.1 and Manufactured Home Installations, Sites
and Communities and ANSI/NFPA 501A or with local
codes.
You can get a copy of the Federal Standard by
Writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010
Electrical Connection
An adequate electrical supply and outlet must be used
to operate the electrical parts of your cooktop.
WARNING
Electrical Grounding Instruction
Plug into a grounded 3 prong outlet. Do not
remove ground prong. Do not use an adapter. Do
not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Important:
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which must be used with a
properly grounded 3-hole outlet with a standard 120
Volt, 60 cycle AC household current. If you do not
have a 3-hole grounded outlet, have a qualified
electrician change your old one. A grounding adaptor
will be needed to convert the old one until the outlet
can be replaced. This method is only temporary, and
a qualified electrician should test it to be sure it meets
requirements.
Electrical Requirements
Do not under any circumstances cut or remove
grounding prong from the cooktop cord.
015
Figure 15.
GROUNDING PRONG