Filter
Top Products
Cooktop & Installation Manual
Model COGB ENGLISH
16
Conversion LP Gas
Converting Appliance for Use with LP Gas
WARNING
Conversion is to be performed by a
AUTHORIZED SERVICER (or other qualified
agency) in accordance with the manufacturer's
instructions and all codes and requirements of the
authority having jurisdiction.
Failure to follow instructions could result in serious
injury or property damage.
The qualified agency performing this work
assumes responsibility for this conversion.
WARNING
Electrical power and gas must be turned off
prior to conversion.
If this appliance should be converted for use with gas
LP (propane or butane), each of the following
modification must be performed:
Replace all Injectors
1. Remove the grates and burner caps.
2. Remove aluminum gas spreader.
3. Loosen injectors by turning 9-32" nut driver
counterclockwise.
4. Change the NG injectors with the LP injectors
supplied with this appliances .The injectors have
small numbers stamped on the side, this number
codes the orifice diameter and its correct burner
location.
5. Install the 4 injector in the appropriate burner
turning clockwise to tighten
(Tighten to a torque of 15 to 20 inch-lbs).
Carefully install the injector in the appropriate
burner, following the illustrations below.
6. Replace aluminum gas spreader, burner caps and
grates.
7. Save the orifices removed from the appliance
for future use.
017
Figure 17.
018
90
105
115
75
Figure 18. 4 burner Model (30” wide)