Filter
Top Products
12
Installation instructions
Gas Connection
Note: Connection to the gas supply may be made using either a rubber hose (where permitted) or
by using a flexible hose or rigid pipe.
Gas connection with a rubber hose
Important !
A rubber hose connection shall only be made if permitted by the applicable local regulations.
The gas connection fitting (Fig. 5a) is made up of:
the appliance inlet pipe;
the floating nut;
the brass elbow;
the washers;
the appropriate hose holder (for NATURAL GAS/TOWN GAS or LPG).
Turning the gas
connection fitting
Appliance
inlet
pipe
Washer
Washer
Washer
Brass elbow
Floating nut
½ ” G cylindrical
(ISO 228-1) male
½ ” G cylindrical
(ISO 228-1) male
½ ” G cylindrical
(ISO 228-1) female
Hose holder for
NATURAL GAS
or TOWN GAS
Hose holder for
NATURAL GAS
or TOWN GAS
Hose adaptor
for LPG
½ ” G cylindrical
(ISO 228-1) female
Hose clamp
(not supplied)
Hose clamp
(not supplied)
Rubber hose (not supplied)
for LPG connection
(internal diameter 8 mm)
Rubber hose (not supplied)
for NATURAL GAS
or TOWN GAS connection
(internal diameter 13 mm)
Gas connection with rubber hose holder
Note: if not already fitted on the inlet pipe, the hose holder
is supplied with the product in a separate kit; if not supplied with the appliance
it can be purchased by contacting Customer Care.
(Important: to be used ONLY IF PERMITTED by the local applicable regulations)
Fig. 5a Gas connection
with a rubber hose
EN