Filter
Top Products
38
Fault codes
Fault codes and
descriptions
Possible causes What to do
E1
The door is open
The door has not been properly
closed or steam has forced it open.
Close the door firmly.
E2
Sensor fault
The temperature sensor is faulty. Turn the water and power to the
dishwasher off, then call Customer
Care.
E3
Drain hose fault
The drain hose is not connected
properly or has come loose.
Ensure that the drain hose is connected
in accordance with the installation
instructions.
E4
Drain fault
Drain hose is crimped or bent. Check the drain hose and straighten
if needed.
The waste water is not draining
out.
Ensure that the drain hose is connected
in accordance with the installation
instructions.
E5
No water
Water tap not turned on. Ensure the water is connected and
turned on.
Insufficient water supply pressure. Check household water pressure.
Water inlet hose is crimped or bent,
so no or not enough water gets to
the dishwasher.
Check the water inlet hose and
straighten if needed.
Drain hose is not connected
correctly.
Ensure that the drain hose is connected
in accordance with the installation
instructions.
E6
Flooding
Flood switch activated. Turn the water off and disconnect
the dishwasher from the power
supply. Call Customer Care.
If the dishwasher malfunctions, it will display a fault code and beep. Check the table below to
see if you can correct the fault yourself before contacting Fisher & Paykel Customer Care.
If the dishwasher still will not work, or shows any other fault code
1
Press to turn the dishwasher off and wait a few minutes.
2
Press again to turn the dishwasher back on.
If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher
from the power supply, turn the water supply off, then contact Fisher & Paykel Customer Care
with the fault code information.