Support User Manuals

Fisher & Paykel OB24SDPX Oven User Manual

Open as PDF

of 56

19

Setting

1. Set the cooking function by turning the oven selector to the function required.

2. The cooking temperature appears on the display. To change it proceed as described

in the Setting the cooking section.

3. Press push button 2. AUTO starts to flash and 0.00 appears.

4. Press push buttons 5 or 6 to set the cooking time (cooking time in hours and min-

utes: set it to ten minutes less than the time required because the stored heat will

complete the cooking).

5. On the display AUTO becomes steady and the cooking program starts.

6. Press push button 3 (AUTO starts to flash).

7. Press push buttons 5 or 6 to set the time when the cooking should finish.

The values set must be correct; e.g. if it is 08:00 a cooking time of 3 hours, ending

at 10:00, cannot be set. In this case the programmer automatically sets the end of

cooking time for 11:00.

8. On the display AUTO becomes steady and the time appears again. The cooking

symbol goes out.

Starting cooking

9. The pan symbol lights up. The oven switches on and the cooking cycle set starts.

AUTOMATIC COOKING

Start cooking at the programmed time and switch the oven off

automatically after the programmed cooking time.

During cooking

10. During the cooking cycle, the display shows the oven temperature measured by

the probe or pre-set temperature.

Press key 2 to display the length of cooking set.

Press key 3 to display when the cooking will finish.

The cooking time, end of cooking time and cooking temperature can be varied at

any time, as described above.

At the end of cooking

11. End appears on the display, AUTO flashes and the audible signal sounds.

The cooking cycle has finished and the oven is OFF.

13. Press any push button to stop the audible signal.

14. OFF appears (oven OFF).

15. Turn the function selector to 0 (OFF).

16. The program display shows the time.

Note: At the end of the program always turn the function selector knob

to 0 (OFF).

IMPORTANT: During AUTOMATIC COOKING PROGRAM the oven light

is always on, also before starting (heating elements on or cycling) of the

programmed cooking.

I

I

I

I

I

I

I

I

I

2 5 6

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

I

3 5 6

I

I

I

I

I

I

I

I

I

I

I

3

previous next