Filter
Top Products
12
Water Supply
The water supply should be ready at the point of installation. The water supply pressure
should be a minimum of 15 psig with a static pressure not more than 80 psig. (A wall
outlet directly behind the ice machine will make installation easier.)
IMPORTANT:
1. All installations must be in accordance with local plumbing code requirements.
Professional installation is recommended.
2. Make certain the hoses are not pinched or kinked or damaged during installation.
3. Check for leaks after connection.
Tools required:
½-in. open-end wrench, Phillips screwdriver
Connecting the water line:
1. Turn off main water supply. Turn on the nearest faucet long enough to clear line of
water.
2. Find a ½-in. to ¾-in. vertical cold water pipe near the installation location. The
distance should be less than 9 feet. The water supply hose provided with the ice maker
is about 9 feet long.
3. A shut-off valve must be installed to the main water supply. If the water pipe has a
plain
piece of copper tubing, attach a ¼” O.D. compression union to the tubing and
remove the nut.
4. Connect the nut of the water supply hose to the tap, and connect the other end with the
water inlet. Tighten firmly by hand, then one-half turn with wrench.
5. Turn on main water supply and tap. Check for water supply connection leaks. Tighten
every connection (including connection at the water inlet).
IMPORTANT: When you connect the water supply hose and the drain hose, pay attention
to the indications of “Water inlet” and “Drain outlet” on the machine.
Drain
Connecting the drain line or not is optional. When you choose to connect the drain line,
you should follow the procedure in “Connecting the drain line “ below. If not, just follow
the steps in “If you don’t connect the drain hose”. However, it is recommended to use the
drain when the ice maker is at high ambient temperature or low ice consumption to avoid
accumulating melt water in the bin.
Connecting the drain line:
NOTE: If there is a drain line near the ice maker, the best choice to drain water to
the drain line through the drain water hose provided with ice maker.
1. Locate the floor drain near the ice maker. The distance should be less than 9 feet since
the length of the long drain water hose provided with the ice maker is about 9 feet.