7
Ice Maker Installation
Unpacking
Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your
ice maker.
Remove tape and glue from your ice maker before using,
? To remove any remaining tape or glue, rub the area briskly with your thumb. Tape
or glue residue can also be easily removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers. Wipe with warm water and dry.
? Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These products can damage the surface of your ice
maker.
? Leave lowermost foam panel in place until after the adjustable feet are attached.
Cleaning before use
After you remove all tape and glue from the machine, clean the inside of your ice maker
before using it. See “Interior Cleaning” in the Cleaning and Maintenance section.
Installing the adjustable feet
At least two persons are required to install the adjustable feet.
You will find four adjustable feet packed in the ice storage bin. To install, tilt one side of
the unit and screw in two adjustable feet, as illustrated. (IMPORTANT: Do not tilt the
unit more than 45º.) Then tilt the other side and screw in the remaining two feet.
4
45
Lower foam panel