Filter
Top Products
22
SETTING OVEN CONTROLS
Suggestions for convect broil:
1. Be sure to carefully follow all the recommended
broil pan and insert instructions and the directions
for placing the oven racks as provided in the "broil"
section in this Use & Care Guide.
2. Since convect broil cooks food faster, reduce the
cook time by 25% from the recommended cook
time of your recipe (check the food at this time). If
necessary, increase cook time until the desired
doneness is obtained.
3. Close the oven door when using convect broil.
Convect broil (some models)
Use the convect broil feature to cook thicker cuts of meats
that require direct exposure to radiant heat and the
convect fan for optimum browing results.
1. Press convect keypad 3 times. 3 times
2. Press start to accept.
To set convect broil (some models) with a default
oven set temperature of 550°F:
Step Press
Some models are not equipped with the convect broil
feature.
NOTE
The convect fan will begin rotating once convect
broil has been activated (some models).
IMPORTANT
To stop convect broil at any time press cancel.
Convect convert
The convect convert feature allows you to convert any
baking recipe for the convect feature. The control uses the
normal recipe settings and adjusts to a lower temperature
for convection baking. The convect convert feature may
only be used when convect baking.
To set convect using default oven set temperature
of 350°F and adding the convect convert:
Step Press
1. Press convect keypad.
2. Press convect convert.
NOTES
• When using convect convert, any cook time
reductions needed may vary depending on the oven
set temperature.
• When baking layer cakes, use the bake feature to
obtain the best results.
• The minimum bake time setting allowed using the
convect convert feature is 20 minutes.
• If the oven door is opened when a convect feature is
active, the convect fan will stop rotating until the
oven door is closed.
To stop convect convert at any time press cancel.
Fig. 1
When convect convert is active with a bake time or a
delay start setting, the convect convert feature will
display the message "CF" for check food when the bake
time is 75% complete (See Fig. 1). At this time the oven
control will sound 1 long beep at regular intervals until
the set bake time has finished.