Filter
Top Products
23
Avoid Transportation Damage to your Range
If you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take the
following precautions:
1. Screw in the levelling legs under the range.
2. Remove the racks and other utensils from the oven, and from the lower drawer.
3. Use adhesive tape to firmly secure the door and the drawer to the side panels. Also attach the electric power cord in the
same manner.
4. Use a two-wheeled trolley with strap and fasten the range to it. Cover the appliance with a heavy blanket to prevent
scratches and dents.
5. Avoid pulling or pushing the control panel when moving the appliance.
SELF CLEANING OVEN (some models)
Avoid Service Checklist (continued)
PROBLEM
Self-cleaning cycle does not work.
Soil not completely removed after
self-cleaning cycle.
POSSIBLE CAUSE/SOLUTION
Control(s) not set properly. Follow instructions under Oven Cleaning in the Electronic Oven
Control section.
Self-cleaning cycle was interrupted. Stop time must be set 3 to 4 hours past the start time.
Follow steps under To Stop or Interrupt a Self-Cleaning Cycle in the Electronic Oven
Control section
Failure to clean bottom, front top of oven, frame or door area outside oven seal. These
areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these
areas before the self-cleaning cycle is started. Burned-on residue can be cleaned with a stiff
nylon brush and water or nylon scrubber. Be careful not to damage the oven seal.