Filter
Top Products
Avoid Service Checklist
22
PROBLEM POSSIBLE CAUSE / SOLUTION
BROILING
AVOID TRANSPORTATION DAMAGE TO YOUR RANGE
If you have to move your range into/out of your residence or when moving to a new home, it is suggested that
you take the following precautions:
1. Screw in the levelling legs under the range.
2. Remove the racks and other utensils from the oven, and from the lower drawer.
3. Use adhesive tape to firmly secure the door and the drawer to the side panels. Also attach the electric
power cord in the same manner.
4. Use a two-wheeled trolley with strap and fasten the range to it. Cover the appliance with a heavy blanket
to prevent scratches and dents.
5. Avoid pulling or pushing the control panel when moving the appliance.
Control(s) not set properly. Follow instructions under Setting Oven Controls in the Electronic
Oven Control section.
Make sure oven door is opened to broil stop position.
Meat too close to the element. Reposition the rack to provide proper clearance between the
meat and the element. Preheat broil element for searing.
Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to
prevent curling, but do not cut into lean.
Grid on broiler pan wrong side up and grease not draining. Always place grid on the broiler pan
with ribs up and slots down to allow grease to drip into pan.
Grease has built up on oven surfaces. Regular cleaning is necessary when broiling frequently.
Old grease or food spatters cause excessive smoking.
Control(s) not set properly. Follow instructions under Oven Cleaning in the Electronic Oven
Control section.
Self-cleaning cycle was interrupted. Stop time must be set 3 to 4 hours past the start time. Follow
steps under To Stop or Interrupt a Self-Cleaning Cycle in the Electronic Oven Control section
Failure to clean bottom, front top of oven, frame or door area outside oven seal. These areas
are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before
the self-cleaning cycle is started. Burned-on residue can be cleaned with a stiff nylon brush and
water or nylon scrubber. Be careful not to damage the oven seal.
Oven smokes excessively during
broiling.
Self-cleaning cycle does not work.
Soil not completely removed after
self-cleaning cycle.
SELF-CLEANING OVEN (some models)