Frymaster CT16 Toaster User Manual


 
2
Upper
Compression
Adjustment
Knobs
Lower
Compression
Adjustment
Knobs
Bun Guide for Heel
and Crown Slots
Holding Tray
LOWER
SETPOINT
BUTTON
ON/OFF
BUTTON
LED
DISPLAY
RAISE
SETPOINT
BUTTON
DISPLAY
TEMPERATURE
BUTTON
REdY
2. CT16 Toaster Operational Description
The CT16 Toaster is designed to produce fresh, uniformly toasted buns on an "as needed” basis. The
countertop-mounted unit consists of a cabinet, a computer, a heating element and a pair of conveyor
assemblies.
When the unit is turned on, an electrical heating element (called a platen) is energized. The platen
heats up to a programmed temperature referred to as the setpoint. At the same time, both conveyor
assemblies are activated. When a bun is placed into one of the slots at the top of the cabinet, the
conveyor belts gently carry it through the unit, with the cut face of the bun passing over the heated
platen. As the bun passes over the platen, it is toasted. At the end of the process, the bun is deposited
onto a holding tray.
The computer allows the operator to adjust the setpoint to obtain desired toasting characteristics.
Compression adjustment knobs also allow the operator to adjust the compression of heels and crowns
as they pass through the toaster.
3. Installation/Setup
Upon arrival, inspect the toaster for concealed damage. Immediately report any damage to the
delivering freight company. Claims must be filed within 15 days after receipt of the unit.
Power Requirements:
ALL ELECTRICALLY OPERATED APPLIANCES MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH LOCAL CODES, OR
IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL CODE (ANSI/NFPA NO. 70-1990) OR THE
CORRESPONDING NATIONAL CODE OF THE COUNTRY IN WHICH INSTALLED.
THIS APPLIANCE IS EQUIPPED WITH A GROUNDING PLUG FOR YOUR PROTECTION AGAINST SHOCK HAZARD AND MUST BE
PLUGGED INTO A PROPERLY GROUNDED RECEPTACLE. DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THIS PLUG!
Voltage: 208VAC or 240VAC depending on model ordered
Frequency: 60 Hz (non-CE) or 50 Hz (CE and Australian models)