Filter
Top Products
6
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
Buns are too thick or too
thin.
A. Compression knobs on an improper
setting for desired compression.
A. Adjust the compression knobs to achieve
desired compression. Moving them to a
lower setting will increase compression.
Moving them to a higher setting will
decrease compression. Make sure both
pairs of knobs are on the same setting.
A. Belt slippage.
A. Shut down and clean unit, paying
particular attention to grooves in rollers
and condition of belts.
Buns are toasting
inconsistently.
B. Incorrect belt speed, faulty platen heater,
or faulty controller.
B. Call FASC.
9. Preventive Maintenance
The toaster should be cleaned on a daily basis. Remove the cover. Remove the belts, wash them in
solution of detergent and warm water, and dry them thoroughly. Use a basting brush or similar soft-
bristled brush to whisk crumbs from the unit. Alternatively, a small vacuum may be used to remove
crumbs from the unit. Wipe down all metal surfaces with cloth dampened with a solution of detergent
and warm water, the wipe again with a cloth dampened with clean warm water. If necessary, use a
stiff-bristled brush to dislodge stubborn residue from the grooves in the rollers, then wipe them down.
Additionally, Frymaster recommends that a Frymaster Factory Authorized Service Technician inspect
this appliance at least annually as follows:
• Inspect all wiring for signs of chafing, kinking, and/or loose connections.
• Verify that all mechanical and electronic components are securely mounted (i.e., screws and nuts
and bolts are tight.)
• Verify that idler roller springs are in serviceable condition (i.e., rollers are held securely in the top of
the J-slots and belts do not slip).