Filter
Top Products
3
• Phase: Single
• Service: 30 Amp
Setup:
Setup of the toaster consists of unpacking the unit, placing it on a sturdy table or countertop adjacent to
a properly grounded AC outlet of appropriate voltage, removing the cardboard packing inserts, installing
the bun feeder in the slot on top of the cover, and plugging it in. NOTE: The cover must be closed to
install the bun feeder, and the bun feeder must be removed to open the cover.
The unit is shipped with a programmed setpoint of 550°F (288°C), upper crown compression knob set
to 4, lower crown compression knob set to 5, upper heel compression knob set to D, and lower
compression knob set to E. The operator may change these settings to attain desired toasting.
4. Operation
1. Press the ON/OFF button. The word LOW will appear in the green LED display window. The
unit will take about 10 minutes to reach operating temperature, at which time the display will change
to REDY, indicating the toaster is ready for use.
2. Load buns into the appropriate slots (Heel or Crown) one at a time, with the cut faces toward the
rear of the unit. The unit will toast the buns and transfer them to the holding tray.
3. Adjust the setpoint and bun compression as necessary to achieve desired toasting.
5. Viewing and Adjusting The Setpoint
To view the platen temperature: Press the button once. The temperature in degrees Fahrenheit
will appear in the green LED display window. To view the current setpoint, press the
button twice.
The setpoint in degrees Fahrenheit will be displayed in the green LED display window.
LOWER
SETPOINT
BUTTON
ON/OFF
BUTTON
LED
DISPLAY
RAISE
SETPOINT
BUTTON
DISPLAY
TEMPERATURE
BUTTON
550F
To change the display from Fahrenheit to Celsius: Unplug the unit, then press and hold the
button as the unit is plugged back in.
To change the setpoint:
1. Turn the unit OFF (press the
button). Enter the setpoint programming mode by pressing the ,
, , buttons in that order. The current setpoint will appear in the LED display. To increase
the setpoint, press the
button; to decrease it, press the button.
2. When the desired setpoint is displayed, press the
button once. Press the ON/OFF button. If
the platen is within 20°F (11°C) of the setpoint, the display will show REDY. Otherwise, the display
will show LOW or HIGH until the platen is within 20°F (11°C) of the setpoint, at which time the
display will change to REDY.