Filter
Top Products
Consumer SupportTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
13
Trim kits and decorator panels.
For CustomStyle™ models
Read these instructions completely and carefully.
Before You Begin
Some models are equipped with trim kits that allow you to install door panels. You can order pre-cut
black or white acrylic decorator panels or stainless steel panels from GE Parts and Accessories,
800.626.2002, or visit our Website, www.GEAppliances.com. In Canada call 1.888.261.3055 or visit our
Website, www.geappliances.ca. Or you can add wood panels to match your kitchen cabinets.
Panels less than 1/4
″
(6 mm) thick
When installing wood panels less than 1/4″ (6 mm) thick, you need to create a filler panel, such as
1/8″ (3 mm) cardboard, that will fit between the face of the door and the wood panel. If you are installing
the pre-cut decorator panels, pre-cut filler panels are included in the kit. The combined thickness of the
decorator or wood panel and the filler panel should be 1/4″ (6 mm).
3/4
″
(19 mm) or Raised Panel
A raised panel design screwed or glued to a 1/4″ (6 mm) thick backing, or a 3/4″ (19 mm) routed
board can be used. The raised portion of the panel must be fabricated to permit clearances of at least
2
5
⁄8″ (67 mm) from the handle side for fingertip clearance.
Weight limitations for custom panels:
Fresh Food 38 lb. (17 kg) max.
Freezer Door 22 lb. (10 kg) max.
2
5
⁄8″ (67 mm)
Clearance
Handle Side
Appearance
Panel
Refrigerator
Door
1/4″ (6 mm)
Thick Backing
3/4″
(19 mm)