Filter
Top Products
14
Consumer Support Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsTroubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Trim kits.
Dimensions for Custom Wood Panels
■ The areas at the top of the freezer panels need to be cut out of the panels.
■ The shaded areas indicate areas that must be routed out by 1/8″ (3 mm) on the backside
(handle side only) of the 1/4″ (6 mm) panel. For panels less than 1/8″ (3 mm) thick, these
areas can be cut out of the filler panels.
Cut-Out
Cut-Out
Cut-Out
24
1
/16″
(61.1 cm)
3/8″ (10 mm)
35
3
/4″ (90.8 cm)
14
7
/8″ (37.8 cm)
15
7
/16″ (39.2 cm)
1/8″ (3 mm)
5/16″ (8 mm)
Freezer Panel
Corner Cut-Out
3
15
/16″ (10.1 cm)
1
3
/4″ (4.4 cm)
Back of Panel
2
5
/8″ (6.5 cm)
Fingertip Clearance
Area to be routed
on back handle
side to allow for
mounting screws
42
1
/4″
(107.3 cm)
35
3
/4″ (90.8 cm)
Cut-Out
Freezer Panel
Without Dispenser
Freezer Panel
With Dispenser
Refrigerator Panel
FRONT
Front of
Panel
1
/4″
(6 mm)
1
/8″
(3 mm)
Top View–Handle Side