Filter
Top Products
16
Inserting the door panels.
Install the Freezer Door Side Trim
Do not remove the protective film on the outside
of the Side Trim until the Side Trim is installed.
Fit the top of the freezer door Side Trim under the
corner of the Top Trim and fit the bottom of the
Side Trim over the Bottom Trim as illustrated.
Attach the Side Trim to the door using the two
screws removed in Step 2. Make sure the Side trim
is fitting correctly and that you are satisfied with
the appearance of all parts before pulling the
blue tape liner.
Holding the trim in place with one hand, gradually
pull the blue tape liner out, perpendicular to the
trim. Pull about 3″ (80 mm) out at a time, pressing
the trim with your hand as the adhesive is exposed.
Install the Refrigerator Door Side Trim
Fit the Side Trim over the ends of the refrigerator
door Top and Bottom Trim as illustrated. Attach
the Side Trim to the door using the two screws
removed in Step 2. Make sure the Side Trim is
fitting correctly and that you are satisfied with
the appearance of all parts before pulling the
two pieces of blue tape liner.
Pull the top blue tape liner up about 3″ (80 mm),
pressing the trim with your hand as the adhesive is
exposed to the door. Then pull the bottom blue
tape liner down about 3″ (80 mm). Follow the tape
with your hand, pressing the trim adhesive against
the door.
Continue pulling the blue tape liner loose,
alternating between the top and bottom and
pressing the Side Trim against the door.
Remove the Protective Film From the Outside of the Side Trim
Consumer Support Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsTroubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions