Filter
Top Products
32
The oven door must be closed and all controls set correctly for the cycle to work properly.
After a Clean Cycle
You may notice some white ash
in the oven. Wipe it up with a damp
cloth after the oven cools.
If white spots remain, remove them
with a soap-filled scouring pad and rinse
thoroughly with a vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
n You cannot set the oven for cooking until
the oven is cool enough for the door to
unlock.
n While the oven is self-cleaning, you can
touch the CLOCK pad to display the time of
day. To return to the clean countdown,
touch the COOK TIME pad.
n If the racks become hard to slide, apply
a small amount of vegetable oil or cooking
oil to a paper towel and wipe the edges
of the oven racks with the paper towel.
Using the self-cleaning upper oven.
How to Delay the Start of Cleaning
Make sure the clock shows the correct time
of day.
Touch the RANGE LOCKOUT pad
and then the START pad to turn it off.
See the Range Lockout section.
NOTE: The surface units must be turned
off prior to the self-clean start time.
Touch the SELF CLEAN pad.
Using the number pads, enter
the desired clean time.
Touch the START TIME pad.
The earliest start time you can
set will appear in the display.
Using the number pads, enter the time
of day you want the clean cycle
to start.
Touch the START pad.
The door locks automatically. The display
will show the start time. It will not be possible
to open the oven door until the temperature
drops below the lock temperature
and the LOCKED DOOR light goes off.
The oven shuts off automatically when
the clean cycle is complete.
When the LOCKED DOOR light is off,
the door will unlock automatically.
n The words LOCK DOOR will flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door.
n To stop a clean cycle, touch the OFF pad.
When the LOCKED DOOR light goes off
indicating the oven has cooled below
the locking temperature, you may open
the door.
Operating
Instructions
Safety InstructionsCare and Cleaning
Installation
Instructions
Troubleshooting
Tips
Consumer Support